entered as follows. Starting at position zero in the buffer,
      enter the Track. Position one, enter the sector to modify.
      Position two, enter the number of bytes you will be
      modifying. Position three, input the starting position of
      that change in the sector to be modified. The bytes from four
      on represent the actual byte changes. After the byte changes
      have been imputed, you have three situations. NUMBER ONE:
      Another change in the same sector. In this case, enter
      one zero byte and number of bytes, position, and actual
      changes again. NUMBER TWO: Another change on disk. Enter two
      zero bytes and then enter all new information just as you did
      in the beginning. Remember, just continue on with your changes.
      Don't start over at position zero. NUMBER THREE: Done. If all
      modifications are entered, enter three zero bytes. This will flag
      the utility that you are finished.

      Press RETURN to lock in all changes.

         S: Save copier/parameter to formatted work disk. Your
            modifications will be automatically executed after the
            created copier has been used. The created copier will contain
            the proper title, tracking information, and byte
            modifications. The user may simply load and run the copier.
            It will allow the use of either one or two drives.

      Kracker-Mon with Relocater and Op-Code Editor

      From the main menu choose option 9 to access this utility. When the
      monitor menu screen comes up, use the cursor U/D keys or the
      1, 2, 3, 4, keys to choose an option. Press RETURN to execute that
      option.

      Kracker-Mon is completely relocatable in memory. The = and - keys
      will increment and decrement the monitor address. Hitting the
      RETURN key while the "Monitor=$X000" is highlighted will also
      increment the monitor to the desired Hex address.

              F1 : Directory of disk in drive.
              F3 : Prompt to re-boot the Hacker's Utility Kit main menu.
        OPTION 1 : Execute chosen monitor. (See Monitor Commands).
        OPTION 2 : Save chosen monitor to a work disk.
                   Saves autoboot file under name: "MONX000". Just
                   LOAD "MONX000",8,1 to autoboot other save files. The
                   op-codes listings will be saved as "OPS". The monitor
                   will be saved as "X0"
        OPTION 3 : Edit the op-code file (OPS) on any WORK DISK.
      CURSOR U/D : Slow scroll through list.
      CURSOR R/L : Fast scroll through list.
         RESTORE : Reset to previous menu.
           SPACE : Allows you to change the mnemonic.
               A : Steps through the addressing modes (changes
                   them).

            K.J. REVEALED TRILOGY    PAGE [157]    (C)1990 K.J.P.B.